Complete Electronics Hardware Design Course 2025 -EsteemPCB
- Descrição
- Currículo
- FAQ
- Revisões
I have divided this course into four major sections:
-
Selection of Components: Choosing each component that will be used in the schematic.
-
Schematic Design: Designing schematics based on datasheet information.
-
Stack-up and Placement: Planning and executing 4-layer, 6-layer, 8-layer, and 12-layer stack-ups, along with component placement.
-
Layout Planning: Inter-block and intra-block layout planning and execution.
The major schematic blocks designed in this course include:
-
Ethernet PHY (10/100 Mb/s)
-
I2S DAC for headphones and speakers
-
MEMS microphone
-
24-bit ADC
-
36W bi-directional brushed DC motor drivers
-
UART to USB TTL converter
-
STM32F103 controller as debugger and programmer
-
STM32F407 main controller
-
Power supply and protection circuits
-
And many more subparts listed in the curriculum.
You will also learn basic blocks such as:
-
Pre-schematic design: Block diagrams and power budgeting
-
Rules for stack-up selection and defining stack-ups
-
Grounding techniques: Signal grounding, earth grounding, chassis grounding
-
Creating rigid-flex PCBs and their stack-ups
-
Pin-mapping using Cube-MX tool
-
Power distribution network (PDN) analysis for PCBs
-
Selection and application of ferrite beads, ESD diodes, and magnetic components
-
Placement and layout planning using Microsoft Paint
After completing this course, you will be able to design mixed-signal PCBs with microcontrollers available worldwide.
The major controllers used in this course are:
-
STM32F407XX
-
STM32F103XX
-
Ethernet PHYs, various sensors, ADCs, and DACs
-
1
Introduction of Section-1 and important instruction -
2
Requirement Sheet Discussion
-
3
Selection of Microcontroller and Debugger
-
4
Selection of Ethernet PHY
-
5
Selection of ADC and TTL Converter
-
6
Selection of Motor Driver
-
7
Selection of MOSFET
-
8
Selection of DAC MIC and I2S Interface
-
9
Block Diagram of Schematic Design Planning
-
15
Introduction of Section-3 and important instruction
-
16
Selection of ESD and TVS diodes
-
17
Selection of Magnetics for PHY
-
18
Ferrite Bead Selection
-
19
Schematic Design for Ethernet PHY Subpart-1
-
20
Schematic Design for Ethernet PHY Subpart-2
-
21
Schematic Design for Ethernet PHY Subpart-3
-
22
IPC STD for Symbol and Footprint
-
30
Introduction of Section-5 and important instruction
-
31
Charge Pump DAC and Mems MIC Schematic Design
-
32
How to Read the Datasheet of STM32F407
-
33
Schematic Design of STM32F407 Subpart-1
-
34
Schematic Design of STM32F407 Subpart-2
-
35
Power Supplies LDOs Selection and Design
-
36
Board Define tools Rigid-Flex PCB and Schematic Templates
-
37
Introduction of Section-6 and important instruction
-
38
Schematic Notes and Footprint Manager before importing Components
-
39
Import Components from SCH to PCBDOC and Rooms Discussion
-
40
Components Placement Planning on Paints
-
41
Components Placement Iteration-1 Subpart-1
-
42
Components Placement Iteration-1 Subpart-2
-
43
Components Placement Iteration-1 Subpart-3
